MTS2000 CPS Mod | Hack 900 MHz band edges

MTS2000 CPS 2.00.03 900 MHz band edges

Open MTS2000.exe using Hex Workshop.
Use the replace command to look for the following hex strings, and then replace them with the provided strings. Make sure you are searching for hex values.

RX Lower Limit / TX TA Lower Limit
935.0125 = 9428BB37
Change to
926.0000 = 80A33137
Replace command should report changes in two places

TX RPT Upper Limit
901.9875 = AC3CC335
Change to
903.0000 = C0AFD235
Replace command should report changes in one place

Save your work (making a backup copy when prompted is re commended), then close Hex Workshop. Open your MTS software, and confirm that you can now enter frequencies within the Ham band without the software flagging them as invalid.  If you can, then you’re all set! If not, delete your existing MTS2000.exe, then rename the extension of your MTS2000.bak file that you created to .exe, then try again



***************************************************************

In case this helps anyone else. This is for the 2.00.03, which is the newest CPS for the MTS2000

Hex edit the mts2000.exe (make a backup first!)

RX Lower Limit / TX TA Lower Limit:
Default Value: 935.0125 = 9428BB37
Found two places in the file: 0x906BB4 and 0x906C8C
Change it to 926.0000 = 80A33137

TX RPT Upper Limit:
Default Value:  901.9875 = AC3CC335
Found one place in the file: 0x906B20
Change to 904.0000 = 00F2E135

http://batboard.batlabs.com/viewtopic.php?f=3&t=110973&p=485076&hilit=Mts2000#p485076


No comments:

Post a Comment

Comments may take a day to show up

A discussion group about this subject.

Amateur Radio - Discussion Support Group
https://groups.io/g/AmateurRadio

Digital Ham Radio / Amateur Radio - Discussion Support Group
https://groups.io/g/DigitalHamRADIO

Note: only a member of this blog may post a comment.